Home > Resources > Knowledges
Search1437 Entries19 Contributors

Introduction to State Plane Analysis

Date: 2019-03-28 14:17:37Posted by: MurphyBlackBook

State plane analysis is often applied to resonant converter, bi-directional dual-active-bridge, trajectory control and some other soft-switching topologies. It is used to reduce complicated tank waveforms to geometry and get an accurate soft-swi...View More

12 Share Collection 0 Comments

Introduction to Modeling of Switched‐Mode Power Converters U...

Date: 2019-04-09 22:11:45Posted by: louis.xi

Extensive introductory tutorials for MATLAB and Simulink, including Control Systems Toolbox and Simulink Control Design are available on the mathworks.com site. Assuming basic familiarity with these tools, the purpose of this document is to introdu...View More

10 Share Collection 0 Comments

DCDC in the electrical vehicle

Date: 2019-04-13 22:01:09Posted by: michael

Traditional fuel vehicle has an engine that can charge a 12V battery. The electrical vehicl does not have an engine, but instead is an electric motor and a high voltage power battery. The power battery is generally 400V, and the low-voltage equipment...View More

10 Share Collection 0 Comments

Power Supply or Power Converter?

Date: 2019-04-23 05:23:01Posted by: mrpower

Power Supply vs. Power Converter These two phrases fundamentally talk about the same thing – a product that takes one form of electricity (voltage, current and frequency) and convert it to another form to meet the needs of loads. There is n...View More

7 Share Collection 1 Comments

Differential (Normal) Mode Noise and Common Mode Noise

Date: 2019-04-23 17:22:09Posted by: Fred

Conducted emission can be classified into two types. One is "differential mode noise", also known as "normal mode noise". These names are sometimes used selectively depending on the conditions that apply, but here we shall assume they are the same...View More

7 Share Collection 1 Comments

Solve the problem of VS2010 automatic closed

Date: 2019-04-23 19:46:26Posted by: Xiufang.Ding

VS2010 software can be opened normally and the control can be added  normally ,but when the program is started, VS2010 software will automatic closed. There may be several reasons and solution are given as below. R easo...View More

7 Share Collection 1 Comments

Wide Bandgap Semiconductors (SiC/GaN)

Date: 2019-04-01 17:40:14Posted by: Sunny

The key for the next essential step towards an energy-efficient world lies in the use of new materials, such as wide bandgap semiconductors which allow for greater power efficiency, smaller size, lighter weight, lower overall cost – or all of thes...View More

7 Share Collection 0 Comments

5G – The high-speed mobile network of the future

Date: 2019-04-09 17:16:23Posted by: Sunny

The next development stage of the mobile network is 5G. This new technology allows a significantly higher data capacity and extremely fast response times. This opens up completely new potential applications for a fully connected society. The super...View More

7 Share Collection 0 Comments